LEEDS AUTOMOTIVE EQUIPMENT
Electric Shutter Door Truck Paint Booth for Sale
Electric Shutter Door Truck Paint Booth
Bus Paint Booth with Roller Door
The paint booth is equipped with electric roller shutters as front door and rear door. The air fans are explosion-proof centrifugal fan
Air draft type: Full Downdraft
•Air Extraction system: single side wall extractors.
•Front door type: 4-fold
•Construction: Steel reinforced and rock wall insulation
•Ceiling and side lighting: 72 pcs LED tubes
•Air Intake System: 4units 4KW centrifugal fans, and air capacity is 40000m3/h.
•Air Exhaust System: The air intake system is composed of 2 units, each unit with two 7.5KW centrifugal fans, and air capacity is 40000m3/h.
•Heating System: 2units G20 diesel burner.
•Filtering: Air Intake Filter - ceiling filter -fiber glass filter- activated carbon filter.
The cabinet settings can be on either side or on a single side, and the single side cabinet setting saves more space.
Model | W-15m |
Booth Dimensions | |
- Internal Size | 15000×5000×5000 mm (L×W×H) |
- External Size | 15150×7770×5900 mm (L×W×H) |
Foundation and Floor | |
- Load Capacity | Depends on the concrete of workshop |
- Surface Area | 16.8 m² , height 660 mm air exhaust boxes at the rear wall |
Wall and Door | |
- Wall Panel | Double wall panels of galvanized steel sheet, thickness 50 mm, inside and outside white, insulated with Rock-wool, high strength and better fire resistance, with tongue and groove interlocking system, mounted at horizontal. |
- Roof Panel | Double wall panels of galvanized steel sheet, thickness 50 mm, inside and outside white, insulated with Rock-wool, high strength and better fire resistance, with tongue and groove interlocking System |
- Panel Edging | 1.2 mm galvanized plate bending forming |
- Entrance Door | 2 Units, 4200×4200 mm (W×H), electric rolling shutter, with door interlock switch |
- Operator's Door | 2 Units, 800×2000 mm (W×H) , observation windows with tempered glass, strengthen metal frame inside, with door interlock switch |
- Plenum Area | 800 mm Height |
Lighting | |
- Ceiling Lightings | 16 Units, each 4×18 W, total 1152 W, LED lamps |
- Side Lightings | 14 Units, each 2×18 W, total 504 W, LED lamps |
- Brightness | > 1000 Lux |
- Protection Level | IP 55 |
Filtration | |
- Pre-filter | G3 level, Fiberglass, double filters, plate filter + pockets filter |
- Ceiling Filters | F5 class filter cotton, Model SP-600G |
- Floor Filters | Fiberglass, Paint-Stop-Filters |
-Exhaust Filters | Fiberglass paint-resistance filters with large ventilation quantity, small resistance and flame resistance, etc. |
Ventilation System | |
- Direct Drive Motor (Fresh Air) | 2×7.5 kW, 415 V, 50 Hz, ABB motor |
- Direct Drive Motor (Exhaust Air) | 2×7.5 kW, 415 V, 50 Hz, ABB motor |
- Fan Capacity | 50,000 m³/h |
- Air Flow Speed | +/- 0.25 m/s in an empty booth |
- Air Duct (Intake & Outlet) | 24 meters straight pipe, 4 reducers, 2 pieces rain-proof hat , 4 elbows , 2 pieces electric damper, 2 pieces manual damper |
- Noise | < 78 dB |
Heating System | |
- Heat exchanger | Stainless steel 1Gr18Ni9Ti (SUS304) |
- Heat capacity | 2×315 kW (2×274,000 kcal/h) |
- Max. Drying Temperature | 80 °C |
- ΔT Temperature Increasing Capacity | 20 °C (from -10°C to 10°C in painting phase) |
- Heating time | 5-10 min (from 20 to 60°C) by Drying Phase |
- Burner Type | RIELLO FS20 Gas Burner |
Control Board (electrical equipment meet AS/ NZS standard) | |
- Control Standard | Y - Δ Start |
- PLC Control | Yes, high reliability & low failure rate |
- Pressure Sensor | Pressure gauge indicates the pressure in booth |
- Function | Painting(warm painting), evaporation, baking, emergency stop switch, failure indication, over-temperature alarm indication, pre-purge and post-purge |
- Frequency Inverter | Excluded (On Option) |
Total Power | 35 KW |
xxxxxx
Your cart is currently empty.